Rotorflight settings
The help for this page of the Version 2 transmitter, as its latest update shows it. On the transmitter, Animation at the top of this help page plays a short film of the page in use.
On the transmitter: Model setupRotorflightSettings
What the transmitter itself needs to know about this model's flight controller.
Touch a white box to type a new value.
'OK' saves them with the model, and goes back to the Rotorflight page.
Link rates and banks
On: the bank switch sets the rates too (Bank 2 uses Rate 2).
Off: the 'Rates' switch sets the rates on its own.
The switch is saved as soon as you touch it.
Rotorflight version
The version the receiver reports from the flight controller:
2.2 or 2.3. It cannot be typed.
0.0 means no Rotorflight is known.
The model remembers what the last connection found, and uses it until the receiver answers. Once found, it stays for the rest of the session, even while the flight controller is silent. After 30 seconds connected with no Rotorflight found, the model starts at 0.0 next time, until it is found again.
At 0.0 the arming channel is not used at all: the safety switch does not drive it and no gap is left out of the count.
'Link rates and banks' has no effect either.
At 2.2 or 2.3 the transmitter's own rate percentages are not used: Rotorflight's rates are.
'Governor ...' needs 2.3.
The Rates page's columns follow each bank's rates type.
Arming channel
The channel the safety switch drives (usually 6), on a Rotorflight model only. Safety off arms the flight controller.
6 to 16: Rotorflight's switches start at channel 6 - or 5, when its channel map puts the arm switch there (ExpressLRS).
Any other entry is ignored: the old channel stays.
Gear ratio (V1 receiver)
Motor turns for one turn of the main rotor, such as 10.3.
A Version 1 receiver uses it to work out the head speed.
A Version 2 receiver does not: Rotorflight sends the head speed.
With a Version 2 receiver, set Rotorflight's own gear ratio on 'First-time basics ...' (its 'Gear ratio' page), not here.
First-time basics
'First-time basics ...' opens four pages for a new model's set-up: swash type, which way the rotor turns, tail type, ESC signal and brand, motor pole count; 'Gear ratio' (main and tail); 'Ports' (what each UART does); 'Throttle calibration' (the ESC's throttle range).
The first two work from the model's backup too; 'Ports' and the calibration need the model itself.
A 'Save' there restarts the flight controller.
Calibrate
'Calibrate ...' teaches the flight controller which way is level, for self-levelling and rescue. It has its own help.
Still stuck?
See common questions, or write to mmessiter@gmail.com. Say which page, and what the screen showed.