LockDownRadioControl

A free, open-source radio control system you can build yourself

Check IDs

The help for this page of the Version 2 transmitter, as its latest update shows it. On the transmitter, Animation at the top of this help page plays a short film of the page in use.

On the transmitter: Model setupModelsCheck IDs

Lists every model memory in use with its stored ID, and finds any ID stored twice.

The Duplicate ID check: eight model memories listed with their stored IDs; models 4 and 8 hold the same ID and are marked same as 8 and same as 4, model 6 has no ID stored, and the line below says 2 of 7 IDs are shared
The page as the transmitter shows it. Tap to enlarge.

Each line shows the model's number, its name and its stored ID.
'same as 8' after an ID means model 8 has the same ID.
'no ID stored' means the model has none yet.
Empty model memories are left out.
The line below the list sums it up.
'All 7 stored IDs are different.' is what you want.
'2 of 7 IDs are shared' means two models have the same ID.
'OK' goes to the 'Model IDs' page, to store or delete an ID.

What the ID is

Each receiver has its own ID: the 6-byte (48-bit) number of its processor chip (its MAC address), shown as 12 characters.
Automatic model selection (AMS) uses it to load the right model memory when a model connects. So each ID must be right, and stored with one model only.

Duplicates

A duplicate can come from moving a receiver to another model, or from restoring a backup into a second model memory.
It can make AMS load the wrong model memory: best avoided!
When an ID is stored twice, the transmitter uses the model now loaded if it has that ID, or else the lowest-numbered one.
To clear a duplicate, load the model that should not have the ID, then press 'Delete stored ID' on 'Model IDs'.

Store and delete

On 'Model setup', then 'Model IDs':
'Store this model's ID' stores the ID of the model now connected, so it can be selected automatically next time.
'Delete stored ID' removes the ID and changes nothing else.

If you are not sure an ID is right

Turn AMS off ('Transmitter setup', then 'System').
Choose the right model on the 'Models' page, and connect.
Then press 'Store this model's ID', and turn AMS on again.

Backups and sending

A backup file keeps the model's ID; a restore brings it back.
A model sent to another transmitter takes its ID with it, if one was stored. With AMS on, that transmitter then selects it when the model connects.

Still stuck?

See common questions, or write to mmessiter@gmail.com. Say which page, and what the screen showed.

↑